How to use the PinConfigure tool and generate GPIO code file and OrCAD/Protel IC components?

Post Reply
a_ziliu
Posts: 207
Joined: 20 Mar 2017, 10:52

31 May 2021, 16:10

Open the NuTool – PinConfigure tool as described below:
1. Select the Chip Series and part number to develop;
2. Check the required Multi-function Pin in the Supported Modules window;
3. User can see the set Multi-function Pin and the position of the IC pin on the right;
4. Click Generate Code to generate the set GPIO initial code (.c file);
5. Click Run NuCAD to generate OrCAD/Protel IC components.

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests