What restrictions do users need to pay attention when using the GPIO De-bounce function?

Post Reply
Posts: 116
Joined: 20 Mar 2017, 10:52

28 Mar 2017, 10:35

The GPIO De-bounce function is used to filter noise or interference on the pin.
After a voltage signal generates a rising or falling edge, if the time to keep high or low level exceeds the De-bounce time set by the user, a GPIO interrupt occurs.
However, there is a limitation related to this function. When the chip is in Power-down mode, the GPIO De-bounce function is turned off. In other words, when the chip is in Power-down mode, once there is a GPIO signal, the GPIO interrupt occurs if the condition of edge-triggered GPIO interrupt is met.

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 0 guests