NuMaker-IoT-M487 PCB mounting holes

Post Reply
Posts: 1
Joined: 02 Aug 2022, 13:53

13 Aug 2022, 14:53

Dear team,

I have bought a NuMaker-Iot-M487 board for evaluation as a replacement for an Olimex STM32F407. I am enjoying using it and developing useful interfaces.

I want to use this board in a new design of our high speed plankton imager as the main system controller. BUT, there are no mounting holes on the four corners of the current PCB (version 1.3). Yet I can look at some of your reference photos (for example: ... &results=2) where PCB mounting holes are shown.

I want to buy more M487 boards, but our application is going underwater at sea and I need mounting holes on the PCB so that I can fix the board securely inside the instrument.

Please tell me that new versions of the PCB will have mounting holes.

regards Phil (Plankton Analytics ltd)

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests