[M480] Ethernet to USB Host Bridge

[chhsieh3]

• Application: This sample code implements a bridge function between Ethernet port and USB host port in the M487 microcontroller (MCU).
• BSP Version: M480 Series BSP CMSIS V3.05.001
• Hardware: NuMaker-PFM-M487 v3.0

This example code implements a USB host to Ethernet bridge function. The function is a part of the Ethernet connection solution. The solution utilizes USB host and device peripherals of M487 microcontroller (MCU) to implement Ethernet frame transfer function between two PC sites. A PC site can send Ethernet frames to the other PC site without considering factors of USB packets. Ethernet frames can be converted into USB packet format automatically by M487 MCU. Then USB packets are converted into Ethernet frames again and received by the other PC site.

You can download the sample code at https://www.nuvoton.com/resource-downlo ... 1228165855

[AnthonPab]

I just found if I plug a USB Ethernet adaptor into my Airconsole, it comes up as an additional routed interface. Is there a way to link this to the LAN port so it works like a switch?

Regards,
Mark.