FAQ_MA35_Family_Change booting source by Buildroot
Posted: 23 Apr 2024, 15:18
The default booting sources for the MA35 series are primarily eMMC/SD. If you've already built an image but wish to change this configuration, you'll need to clean the arm-trusted-firmware, U-Boot, and rebuild them again. Here are the steps:
1. Change the booting source to your preference:
2. Clean arm-trusted-firmware and uboot
Notice:
This command will delete output/build/arm-trusted-firmware-custom and output/build/uboot-custom.
Remember to back up any modifications you have made in these two folders.
3. Rebuild whole Image
#MA35 #Booting #Buildroot
1. Change the booting source to your preference:
Code: Select all
# make menuconfig
Bootloaders --->
U-Boot configuration (Using an in-tree board defconfig file) --(ma35d1_sdcard1) Board defconfig
Notice:
This command will delete output/build/arm-trusted-firmware-custom and output/build/uboot-custom.
Remember to back up any modifications you have made in these two folders.
Code: Select all
# make arm-trusted-firmware-dirclean uboot-dirclean
Code: Select all
# make