First, you need to enter U-Boot stage and following the below command.
Start the USB:
Code: Select all
$ usb start
Code: Select all
- usb start:
- usb reset: (re)starts the USB. All USB devices will be initialized and a device tree is build for them.
- usb tree: shows all USB devices in a tree like display
- usb info [dev]: shows all USB infos of the device dev, or of all the devices
- usb stop [f]: stops the USB. If f==1 the USB will also stop if an USB keyboard is assigned as stdin. The stdin is then switched to serial input.
Code: Select all
usb test [dev] [port] [mode] - set USB 2.0 test mode (specify port 0 to indicate the device's upstream port) Available modes:
J, K, S[E0_NAK], P[acket],F[orce_Enable]
# usb test 1 1 P
Device 1
Port 1
Mode P
#USBH #Eye Diagram