Question :
How to Set the Power-On-Setting of EVB Board?
Answer.
Platform: MA35D1
Platform resource link: https://www.nuvoton.com/products/microp ... -a35-mpus/
BSP link: https://github.com/OpenNuvoton/MA35D1_NuWriter
Configure Power-on Setting:
Make sure the power-on setting for the booting source selection on the DIP Switch (SW7)
followed the correct ON/OFF states shown in Table.
(Refer to User Manual : https://www.nuvoton.com/products/microp ... nual&tab=2)
After choosing the correct power-on setting on these DIP switches, the evaluation environment will boot
from the image stored when power is supplied to the EVB board.
NuMaker-HMI-MA35D1-S1
NuMaker-IoT-MA35D1-A1
#MA35D1 #Power-On-Setting #switch #boot #HMI_EVB #IOT_EV
.
FAQ_MA35D1_EVB_Power-On-Setting
-
- Information
-
Who is online
Users browsing this forum: No registered users and 20 guests