NuForum

• Application: This example code uses M451 CAN interface to upgrade firmware for APROM.
• BSP Version: M451 Series BSP CMSIS V3.01.001
• Hardware: NuMaker-PFM-M453

The C_CAN consists of the CAN Core, Message RAM, Message Handler, Control Registers and Module Interface. The CAN Core performs communication according to the CAN protocol version 2.0 part A and B. The bit rate can be programmed to values up to 1 MBit/s. For the connection to the physical layer, additional transceiver hardware is required.

This example code uses M451 CAN interface to upgrade firmware on the NuMaker-PFM-M453 board.

You can download the sample code at https://www.nuvoton.com/resource-downlo ... 1222102848