Nu-Link_Command_Tool_V2.01.6592 problems...
Posted: 31 May 2017, 12:52
We have installed
NuMicro_ICP_Programming_Tool_V2.01.6592
and that connects, and finds target fine.
However, when we try what sounds like the matching
Nu-Link_Command_Tool_V2.01.6592
it will discover the NuLink ID ok, and confirm the version OK at 6592, but fails to see any connected device,
"Cannot find target IC chip connect with NuLink.!!!"
that the NuMicro_ICP_Programming_Tool_V2.01.6592 finds just fine.
The DOCs claim this
Revision 2.01.6592 (Released 2017-01-13)
1. Supported NUC121, NUC125, NUC126, M0564, NM1810 and I91200 series.
Revision 2.00.6561 (Released 2016-07-22)
1. Supported 8051 1T series (N76E885, N76E884, N76E616, N76E003, N76E002).
2. Added “checksum verify” function for M451 series.
3. In offline mode, added SN (serial number) function for NUC505 series.
4. Use “page erase” instead of “chip erase” if only partial flash segments are programmed, user can preserve configuration page in that case.
but it seems these two V2.01.6592, are actually NOT quite the same, and the command line version fails to see Device ? (they are both dated Jan 6th 2017)
Can someone in Nuvoton confirm Nu-Link_Command_Tool_V2.01.6592, does work properly with N76E003 target ?
If not, when will that be updated ?
NuMicro_ICP_Programming_Tool_V2.01.6592
and that connects, and finds target fine.
However, when we try what sounds like the matching
Nu-Link_Command_Tool_V2.01.6592
it will discover the NuLink ID ok, and confirm the version OK at 6592, but fails to see any connected device,
"Cannot find target IC chip connect with NuLink.!!!"
that the NuMicro_ICP_Programming_Tool_V2.01.6592 finds just fine.
The DOCs claim this
Revision 2.01.6592 (Released 2017-01-13)
1. Supported NUC121, NUC125, NUC126, M0564, NM1810 and I91200 series.
Revision 2.00.6561 (Released 2016-07-22)
1. Supported 8051 1T series (N76E885, N76E884, N76E616, N76E003, N76E002).
2. Added “checksum verify” function for M451 series.
3. In offline mode, added SN (serial number) function for NUC505 series.
4. Use “page erase” instead of “chip erase” if only partial flash segments are programmed, user can preserve configuration page in that case.
but it seems these two V2.01.6592, are actually NOT quite the same, and the command line version fails to see Device ? (they are both dated Jan 6th 2017)
Can someone in Nuvoton confirm Nu-Link_Command_Tool_V2.01.6592, does work properly with N76E003 target ?
If not, when will that be updated ?