The default state of GPIO after reset may vary depending on the product series.
The state of GPIO for M051 BN and NUC100 Series is in Quasi-bidirectional mode with weakly pull-high resistor (110 kΩ~300 kΩ), and the state of GPIO for Mini51 and Nano100 Series is in Input mode.
However, the state of GPIO for M051 DN/DE and NUC200 Series depends on the setting of CIOINI (Config0[10]).
If CIOINI is set to 1, all pins will be in Quasi-bidirectional mode after reset.
If CIOINI is cleared to 0, all pins will be Input mode after reset.
What is the default state of General Purpose Input/Output (GPIO) after reset?
林昌宏/ Henry
新唐科技 / nuvoTon technology corporation
新竹科學工業園區30077研新三路4號
TEL : (03) 5770066#38077
Email : CHLIN55@nuvoTon.com
新唐科技 / nuvoTon technology corporation
新竹科學工業園區30077研新三路4號
TEL : (03) 5770066#38077
Email : CHLIN55@nuvoTon.com
-
- Information
-
Who is online
Users browsing this forum: Bing [Bot] and 27 guests