How to use Nu-Link or Nu-Link Pro to do Offline Programming?

Post Reply
a_ziliu
Posts: 116
Joined: 20 Mar 2017, 10:52

27 Mar 2017, 14:52

Once you open the ICP Programming Tool, you can click on the "Options" in the "Programming" section, as shown in Figure 1, to enable programming options.

Figure 1

In the programming options, check the "Offline Programming Mode" in the "Operation" section, as shown in Figure 2, to enable the offline programming function.

Figure 2

When you start programming, the loaded file is saved in Nu-Link or Nu-Link Pro's offline Flash. After that, you can do offline programming using the Nu-Link or Nu-Link Pro without connecting to the ICP Programming Tool. By pressing the upper left button on the Nu-Link, as shown in Figure 3, you can start programming.

Figure 3

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest