Application: This example code uses MS51 PWM to output 10 kHz waveform with 0~100% duty cycle according to 0~3V ADC input voltage. BSP Version: MS51_Series_BSP_Keil_V1.00.004 Hardware: NuTiny-MS51DA V1.1 This example code uses MS51 PWM to output 10 kHz waveform with 0~100% duty cycle according to 0...

Application: This example code uses the M032 series microcontroller (MCU) to implement USB Disk and FatFs function. BSP Version: M031 Series BSP CMSIS V3.05.000 Hardware: NuMaker-M032LD V1.1 This example code uses the M032 series microcontroller (MCU) to run USB mass storage functions and FatFs fil...

Application: This example is an application code for CAN bus, which describes how to recover and let a device re-enter the bus for packet transmission and reception when a bus off occurs at the device node. BSP Version: M480 Series BSP CMSIS V3.05.003 Hardware: NuMaker-PFM-M487 V3.0 This example is...

Application: This example code uses NuMaker-M258KG as an example to show how to complete a COM/SEG LCD project using NuTool-LCDView. BSP Version: M251_M252_M254_M256_M258_Series_BSP_CMSIS_V3.02.003 Hardware: NuMaker-M258KG V1.1 NuTool-LCDView is a powerful tool that can generate LCD configuration c...

Application: This example code is used for the M031 series microcontroller (MCU) to transfer data between SPI and 4 UARTs. BSP Version: M031_Series_BSP_CMSIS_V3.05.000 Hardware: NuMaker-M031KI V1.0, NuMaker-M031SE V1.1 This example code is used for the M031 series microcontroller (MCU) to send and ...

Application: This example code uses ISP_UART bootloader program in LDROM with IAP mode function to upgrade firmware in APROM through ESP32 BLE module. BSP Version: M031_Series_BSP_CMSIS_V3.05.000 Hardware: NuMaker-M032KI V1.0 This example code uses ISP_UART bootloader program of the M031 series mic...

Application: This LDROM sample code divides APROM into run part and backup part. To restore the firmware in APROM, two parts are compared and updated after power cycling. BSP Version: M480 Series BSP CMSIS V3.05.003 Hardware: NuMaker-PFM-M487 V3.0 This LDROM sample code supports APROM update via UA...

Application: This sample code uses the M031/M032 series microcontroller (MCU) to read a touch screen signal and analyze the position of the finger touch. This document will describe how to configure the ADC to read the signal, and how to configure the SPI to transmit data to the host. BSP Version: ...

Application: This sample code shows how to import GPIO PWM and GPIO Capture driver into the Linux kernel, realize PWM output and detect the change status of pins. BSP Version: Linux-5.10.x Hardware: NuMaker-IOT-MA35D1 V2.0 This sample code demonstrates how to simulate the PWM signal through the “GP...

Application: This example code uses M030G I2C to read NCT7712Y thermal sensor. BSP Version: M030G_Series_BSP_CMSIS_V3.02.000 Hardware: NuMaker-M030GTD V1.2 Microcontrollers (MCUs) are widely used in different ambient temperatures. Nuvoton NuMicro® Cortex®–M0 M030G/M031G series MCUs are provided wit...